The following parts are compatible with the Ultimaker 2+ Connect.
If you have an Ultimaker 2, Ultimaker 2 Extended, or Ultimaker 2 Go please see this collection.
If you have an Ultimaker 2+ or Ultimaker 2+ Extended, please see this collection.
Olsson Block Nozzle - Brass - 0.6mm
$11.00
This nozzle fits the Olsson block set (which is standard on the Ultimaker 2+ and Extended+). This nozzle is also compatible with the Ultimaker 2+ Connect. The larger 0.6mm opening size allows for faster volumetric print speeds than the standard 0.4mm nozzle.
View full product details
Olsson Block Nozzle - Brass - 0.8mm
$11.00
This nozzle fits the Olsson block set (which is standard on the Ultimaker 2+ and Extended+). This nozzle is also compatible with the Ultimaker 2+ Connect. The larger 0.8mm opening size allows for faster volumetric print speeds than the standard 0.4mm nozzle.
View full product details
Olsson Block Nozzle - Brass - 0.25mm
$11.00
This nozzle fits the Olsson block set (which is standard on the Ultimaker 2+ and Extended+). This nozzle is also compatible with the Ultimaker 2+ Connect. The smaller 0.25mm opening size allows for finer detail in the X/Y plane, compared to the standard 0.4mm nozzle, however,...
View full product details
Ultimaker 2 Isolator Spacer 9.4mm (UM2+/UM2X+/Connect)
$9.99
This 9.4mm spacer sits between hot end holder top and TFM coupler on the UM2+/UM2X+ printhead. It can replace the printhead spring on the UM2Go/UM2/UM2X. Official Ultimaker spare part, compatible with the following printers: Ultimaker 2+ Connect Ultimaker 2+ Ultimaker...
View full product details
Olsson Block Nozzle - Brass - 0.4mm
$17.80
This nozzle fits the Olsson block set (which is standard on the Ultimaker 2+ and Extended+) and is a direct replacement for the standard 0.4 nozzle tip. Compatible with the: Ultimaker 2+ Ultimaker 2 Extended+ Ultimaker 2+ Connect Ultimaker 2 with Extrusion...
View full product details
Olsson Block Nozzle - Brass - 0.15mm
Sold Out
This nozzle fits the Olsson block set (which is standard on the Ultimaker 2+ and Extended+). The very small 0.15mm opening size allows for very fine detail in the X/Y plane, compared to the standard 0.4mm nozzle. Note: This nozzle is for expert users only; it...
View full product details
Olsson Block Nozzle - Brass - 2mm
$14.00
This nozzle fits the Olsson block set (which is standard on the Ultimaker 2+ and Extended+). The larger 2mm opening size allows for extremely high volumetric print speeds compared to the standard 0.4mm nozzle, albeit with a greater risk of oozing, and a loss of...
View full product details