Products
Olsson Block Nozzle - Brass - 0.15mm
Sold Out
This nozzle fits the Olsson block set (which is standard on the Ultimaker 2+ and Extended+). The very small 0.15mm opening size allows for very fine detail in the X/Y plane, compared to the standard 0.4mm nozzle. Note: This nozzle is for expert users only; it...
View full product details
Olsson Block Nozzle - Brass - 0.25mm
$11.00
This nozzle fits the Olsson block set (which is standard on the Ultimaker 2+ and Extended+). This nozzle is also compatible with the Ultimaker 2+ Connect. The smaller 0.25mm opening size allows for finer detail in the X/Y plane, compared to the standard 0.4mm nozzle, however,...
View full product details
Olsson Block Nozzle - Brass - 0.4mm
Sold Out
This nozzle fits the Olsson block set (which is standard on the Ultimaker 2+ and Extended+) and is a direct replacement for the standard 0.4 nozzle tip. Compatible with the: Ultimaker 2+ Ultimaker 2 Extended+ Ultimaker 2+ Connect Ultimaker 2 with Extrusion...
View full product details
Olsson Block Nozzle - Brass - 0.6mm
$11.00
This nozzle fits the Olsson block set (which is standard on the Ultimaker 2+ and Extended+). This nozzle is also compatible with the Ultimaker 2+ Connect. The larger 0.6mm opening size allows for faster volumetric print speeds than the standard 0.4mm nozzle.  Â
View full product details
Olsson Block Nozzle - Brass - 0.8mm
$11.00
This nozzle fits the Olsson block set (which is standard on the Ultimaker 2+ and Extended+). This nozzle is also compatible with the Ultimaker 2+ Connect. The larger 0.8mm opening size allows for faster volumetric print speeds than the standard 0.4mm nozzle.  Â
View full product details
Olsson Block Nozzle - Brass - 2mm
$14.00
This nozzle fits the Olsson block set (which is standard on the Ultimaker 2+ and Extended+). The larger 2mm opening size allows for extremely high volumetric print speeds compared to the standard 0.4mm nozzle, albeit with a greater risk of oozing, and a loss of...
View full product details
Steel Nozzle - 0.5mm
$13.00
This nozzle fits the Olsson block set, and provides a more wear-resistant tip that is better suited to printing with abrasive materials like Stainless Steel, or Carbon Fiber filaments. *Note: the opening in these nozzles is 0.5mm - some earlier...
View full product details
Ultimaker Print Core CC .4mm (S3/S5/S7/Factor4)
Sold Out
Ultimaker’s CC 0.4 mm Print Core enables you to print using abrasive materials on your S-series or UltiMaker Factor 4 3D printer. This new print core contains a highly wear-resistant hardened steel nozzle and titanium heat break, making them more...
View full product details
Ultimaker Print Core CC .6mm (S3/S5/S7/Factor4)
$299.00
 Ultimaker’s CC 0.6 mm Print Core enables you to print using abrasive materials on your Ultimaker S-Series or Factor 4 3D printer. This new print core contains a highly wear-resistant hardened steel nozzle and titanium heat break, making them...
View full product details