Products
Hot-End Pack (UMO/UMO+)
$73.15
Hot end parts pack comprising the heater block, nozzle and brass tube, plus teflon isolator, PEEK insulator. Also includes the Bowden tube retaining collet and blue clip. Official Ultimaker spares for the Ultimaker Original and Original+.  This product ships directly from the...
View full product details
Olsson Block Nozzle - Brass - 0.15mm
Sold Out
This nozzle fits the Olsson block set (which is standard on the Ultimaker 2+ and Extended+). The very small 0.15mm opening size allows for very fine detail in the X/Y plane, compared to the standard 0.4mm nozzle. Note: This nozzle is for expert users only; it...
View full product details
Olsson Block Nozzle - Brass - 0.25mm
$11.00
This nozzle fits the Olsson block set (which is standard on the Ultimaker 2+ and Extended+). This nozzle is also compatible with the Ultimaker 2+ Connect. The smaller 0.25mm opening size allows for finer detail in the X/Y plane, compared to the standard 0.4mm nozzle, however,...
View full product details
Olsson Block Nozzle - Brass - 0.4mm
$17.80
This nozzle fits the Olsson block set (which is standard on the Ultimaker 2+ and Extended+) and is a direct replacement for the standard 0.4 nozzle tip. Compatible with the: Ultimaker 2+ Ultimaker 2 Extended+ Ultimaker 2+ Connect Ultimaker 2 with Extrusion...
View full product details
Olsson Block Nozzle - Brass - 0.6mm
$11.00
This nozzle fits the Olsson block set (which is standard on the Ultimaker 2+ and Extended+). This nozzle is also compatible with the Ultimaker 2+ Connect. The larger 0.6mm opening size allows for faster volumetric print speeds than the standard 0.4mm nozzle.  Â
View full product details
Olsson Block Nozzle - Brass - 0.8mm
$11.00
This nozzle fits the Olsson block set (which is standard on the Ultimaker 2+ and Extended+). This nozzle is also compatible with the Ultimaker 2+ Connect. The larger 0.8mm opening size allows for faster volumetric print speeds than the standard 0.4mm nozzle.  Â
View full product details
Olsson Block Nozzle - Brass - 2mm
$14.00
This nozzle fits the Olsson block set (which is standard on the Ultimaker 2+ and Extended+). The larger 2mm opening size allows for extremely high volumetric print speeds compared to the standard 0.4mm nozzle, albeit with a greater risk of oozing, and a loss of...
View full product details
Steel Nozzle - 0.5mm
$13.00
This nozzle fits the Olsson block set, and provides a more wear-resistant tip that is better suited to printing with abrasive materials like Stainless Steel, or Carbon Fiber filaments. *Note: the opening in these nozzles is 0.5mm - some earlier...
View full product details