$19.98
A pair of the spring clips for holding the glass in place. These clips can be used on all 4 corners of the bed, or on the back two corners as preferred. These are official Ultimaker spare parts, compatible with the following...
View full product details$50.50
Glass print bed approximately 9" x 10". Official Ultimaker spare part compatible with the following printers: Ultimaker 2+ Connect Ultimaker S3 Ultimaker 3 Ultimaker 3 Extended Ultimaker 2+ Ultimaker 2 Extended+ Ultimaker 2 Ultimaker 2 Extended Ultimaker Original+ Ultimaker Original with Official...
View full product detailsSold Out $50.50
Official Ultimaker spare part for the Ultimaker S5. OEM glass bed, direct from Ultimaker.
View full product details$22.40
This is the cable that runs between the main electronics and the heated bed panel on the Ultimaker 2+, Ultimaker 2 Extended+, and Ultimaker Original+. This is an updated version of the cable, released in 2016. If your heated bed...
View full product detailsSold Out $120.00
OEM heated bed panel and cable for the Ultimaker 2+ Connect. The bed and cable set is compatible with the following machines: Ultimaker 2 Ultimaker 2 Extended Ultimaker 2+ Ultimaker2 Extended+ Ultimaker Original+ (and the Ultimaker Original with Official Heated Bed Upgrade...
View full product details$229.20
OEM aluminum plate with heater mat, cable, and heat resistant zip tie for the UltiMaker S3. This product is not compatible with any other models of UltiMaker printers.
View full product details